Stilt Covers - Gold with Burgundy 78.5" length - FLAWED
Costumes for Stilt Walkers - Leg Cuff Stilt Covers
Stilt Covers - Gold with Burgundy 78.5" length - FLAWED
ONLY 1 set available of these cuffs
The fabric of these stilt covers is NOT stretchy.
Please be sure your measurements are correct.
The fabric of these pants is damaged/flawed, but I didn't want to throw it away, it is perfectly usable and the damage is only to the interior seam of the legs and is barely noticeable.
The flaw is along the interior seam where the needle I was using had a hiccup as I sewed, I'd not used this type of fabric before and it definitely responded differently than the spandex I usually sew, so this set came out with a tiny bit of damage as shown in the images of the product, that is why this set is priced lower compared to the other sets in the store.
Product Measurements:
78.5" total length
19-23" upper elastic
34" at foot area (approx halfway down the length)
34" bottom cuff, hemmed
FABRIC CARE INSTRUCTIONS:
Gentle Machine Wash or Hand Wash.
No bleach, light detergent
Lay flat, hang to dry, or machine dry on low
Okay to iron with steam IF you use a separate piece of fabric or paper bag between the fabric and the iron.
Kricket Caffery and PegStilts.com is not responsible if you damage your fabric due to mistreatment, not following care instructions, or falling down.
Sizing Help for Leg Cuffs for Stilts:
FINDING MAXIMUM LENGTH:
1) Measure your inseam (from the top of your inside of your thigh to the floor)
2) Add the height of your stilts to your inseam measurement
3) Subtract 4-6" for floor clearance (you don't want your pants/cuffs to go all of the way to the floor, it is a tripping/slipping hazard)
The measurement you get from doing steps 1-3 above is the maximum length of leg cuffs you would want.
FINDING MINIMUM LENGTH:
1) Measure from the top of your kneepads to the floor
2) Add the height of your stilts to the measurement above
3) Subtract 4-6" for floor clearance (you don't want your pants/cuffs to go all of the way to the floor, it is a tripping/slipping hazard)
The measurement you get from doing steps 1-3 above is the minimum length of leg cuffs you would want.
Remember:
You can hem or roll pants/covers that are too long.
You can adjust stilt covers by pulling them up or lowering them down your thigh.
These stilt covers are made for peg stilts and most drywall stilts.
DRYWALL STILT USERS: Please measure the circumference of the widest point of your stilts to be sure these pants will work for you.
These leg cuffs are NOT made for use with bouncy/jumping stilts.
